home
vyse amps
Info
About us
 

guitar modification kits

VGK Volume Kit    BLUGK Bluescaster    SMGK Super Midrange

Simple kits & parts for modifying any electric guitar

£

GUITAR MIDRANGE KIT - PART # GMGK
Our famous guitar midrange kit. A simple control that cuts out the midrange from electric guitars, giving a smooth, acoustic-like tone. The kit includes the parts to assemble on an existing Tone pot. Very easy installation and great results.
6.50

SUPER MIDRANGE KIT - PART # SMGK
An entirely new tone control for guitars. It not only cuts midrange (from 0 to 5) but also boosts (from 5 to 10). Only 2 wires to install. Complete with the control pot.

unassembled
19.50
assembled
27.25

SUPER MIDRANGE DELUXE KIT - PART # SMDK
As above but with push pull pot for additional range of tone controls.
30.70
VOLUME KIT - PART # VGK
A simple and effective kit to retain the highs when the volume control on the guitar is turned down. Works great on all guitars all the time.
1.65

VARI-VOL KIT - PART # VVK
Rotary switch replacement for your guitar volume pot

19.50
VARI-TONE KIT - PART # VTGK
A set of tone filters on a 6 position rotary switch similar to that found on some Gibsons. A bypass option plus 5 tones including ‘out-of-phase’ and midrange cut / midrange boost.
unassembled
15.25
assembled
26.10
BASS VARI-TONE
unassembled
15.25
assembled
30.65

DELUXE VARI-TONE KIT - PART # DVGK (fully wired)
A more advanced version of our Vari-Tone Kit (above). Includes the 6 position tone filter, plus a separate push-pull pot that changes the tonal range of the 5 filters giving 5 more sounds, plus a blend, or mix control for the entire effect. The ultimate in Tone tricks. Easy 2 wire installation.

unassembled
32.90
assembled
39.20

1 MEG POT - PART # 1MGK
A replacement for the Volume Control in electric guitars. It will increase the gain of the pickups and make the guitar brighter. Recommended for ‘hot’ or high-performance pickups. Includes VGK
4.90
2 MEG POT - PART # 2MGK
A 2 Meg pot will increase the gain and brilliance of high gain pickups even more than a 1 Meg pot. Recommended for high-gain pickups only. Includes Volume Kit VGK.
4.90
DUNLOP CRYBABY STANDARD MODIFICATION -PART# DCSK
An easy mod to the Crybaby Wah pedal to get a warmer richer tone. Minor soldering only.
10.50
DUNLOP CRYBABY DELUXE FIVE-WAY MOD - PART# DCD5GK
Adds a 6-position switch to the pedal to give a choice of 5 warmer tones and a bypass of the modification for the original tone of the pedal. Requires some assembly and the drilling of a 3/8" hole in the side of the pedal.
26.10
DUNLOP CRYBABY TRUE BY-PASS - PART#DCTB
Replacement DP-DT Footswitch to provide true bypass
19.50
DUNLOP CRYBABY: POT REPLACEMENT - PART#DCHP
32.90
BLUESKASTER WIRING HARNESS FOR STRAT-TYPE GUITARS - PART# BLUGK
A great setup for 3 pickup Strat-type guitars. Includes a new volume control with Volume Kit (VGK) installed, a Super-Midrange (SMGK) tone control blender pot and a high quality new 5-position switch, all pre-wired ready to go.
69.25
BLUESKASTER WIRING HARNESS KIT PARTS ONLY
As above, but needs wiring up.
48.80
BLUESKASTER WIRING HARNESS DELUXE VERSION WITH PUSH-PULL TONE POT
88.55
BLUESTONE WIRING HARNESS FOR TELECASTER-TYPE GUITARS - PART# TELEK
An all-new wiring for Telecaster-type guitars. It uses a 5 position switch to get a whole new range of tones including pickups in series, parallel, and with the midrange boosted. Fully assembled. Also available as modification for Kinman pickups at no extra cost.
77.20
BLUESTONE WIRING HARNESS KIT PARTS ONLY
As above, but needs wiring up.
51.10
TONE BOX
Free-standing tone control combining both varitone and deluxe super midrange controls and true by-pass on footswitch! Works with any guitar - just plug in between guitar and amp
64.75

A/B BOX
A simple but very useful footswitch, allows passive switching between a guitar input and two outputs. Can be used to A/B between two separate channels of an amp - in effect converting the amp to footswitchable dual channel or to create a true bi-pass to a stage tuner. Robust, gig-able construction. Uses no batteries. Does not affect the guitar's original tone or gain.

29.50
CUT BOOST FOOTSWITCH
Another simple but useful footswitch....ever wanted to boost a lead riff or solo on a single channel amp, without colouring the tone through effects pedals? The VyseAmp 'Cut/Boost' pedal allows true bi-pass switching between normal guitar output and an output with a variable volume cut. Set up a rhythm level in the cut mode and switch to normal for a natural solo 'boost'. Can be used from amp to guitar or in amps effects loop. Incorporating the Torres 'Volume Kit'. Solid enough for any gig. Uses no batteries.
35.20
Torres A/B and A+B foot switch, with click of a button move from one amp to another or play both together

59.10


Back to Top



If you have any comments, criticisms, praise, questions or suggestions, or would like to place an order, please either send us an email
İVyse Ltd 2000